Omron CQM1 Operation Manual page 280

Application
Operation Control
Commands
1,2,3...
Note If the contents of IR 100 are left unchanged, the process value in
IR 001 will be updated every 500 ms.
The following procedure would be used to switch to RUN status for all loops.
1. Start by monitoring IR 001 and IR 1000 on the Programming Console.
? ?
? ?
2. Write "CCDA" to the output word to specify RUN status for all loops.
"CCDA" will be written to the input word to acknowledge the command.
? ?
++,) ++,)
Section 2-6
261