Table of Contents
Advertisement
3
In the [Box] group list, select the target box to set.
4
Press the [Edit DNS Server] button.
The [DNS Server Settings] window appears.
5
Press the [Mode] button and select a setup mode from
the pull-down list.
Off: Do not use a DNS server.
Manual: Set manually.
DHCP: Set automatically using DHCP.
When [Manual] is selected, proceed to step 7.
When [Off] is selected, proceed to step 9.
Note
If there is no LAN with network interface setup mode
set to DHCP on the target box, [DHCP] cannot be
selected.
6
Select a LAN for obtaining DNS in [LAN].
Press the button on the left and select a LAN from the
pull-down list, then press the button on the right and
select IPv4 or IPv6 from the pull-down list.
Proceed to step 9.
Note
LANs that are set to a network interface setup mode
other than DHCP cannot be selected.
7
Press the [Domain Name] button and enter a domain
name using the keyboard.
8
Press a [Server 1] to [Server 4] button and enter a
server address using the keyboard.
Enter an IPv4 address or IPv6 address.
9
Press [OK].
10
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then
press [OK].
11
Check the message, then press [OK].
To identify a box
Select the target box from the [Box] group list and press
the [Send Beacon] button to cause the front panel LED
bars on the selected box to flash for 5 seconds.
Configuring 100G IP Network
Settings
You can configure the network settings of the 100G IP
interfaces of each box that is not assigned to an island that
has MKS-X1110 IP Input & Output Boards installed for
input/output.
Each box that has MKS-X1110 IP Input & Output Boards
installed for input/output is equipped with eight 100G IP
ports (M/E box) or four 100G IP ports (cross-point box).
Ports for Slot/LAN with suffix of "-1" are used for the ST
2110 transmission primary network, and ports for Slot/
LAN with suffix of "-2" are used for the secondary
network. You can configure the following network
settings of each port.
• FEC type
• IPv4 IP address/prefix length
• Gateway
1
Open the MLS Manager Home > System > Off-Island
> 100G IP Network menu (60219.02).
2
Press the [Detect/Refresh] button.
The LAN ports of the 100G IP interfaces of boxes
that are on the same network as MLS Manager and
not assigned to an island are detected.
Note
If no connections with boxes corresponding to the
LAN port are detected, the
Press the [Detect/Refresh] button to run LAN port
detection again.
3
Select the target LAN port to set.
Place a check mark for the target LAN port to set
(multiple selection supported).
To select and set all LAN ports, place a check mark
in the Select All checkbox.
4
Press the [FEC] button and select an FEC type.
RS-FEC: Use Reed-Solomon FEC (CL91).
None: Do not use FEC.
Note
When multiple LAN ports are selected, the same FEC
type is set on all ports.
5
Press the [IP Address] button and enter an address
using the keyboard.
Notes
• When multiple LAN ports are selected,
consecutively numbered IP addresses are set.
487
icon is displayed.
Advertisement
Table of Contents
