a) You can change the switcher bank (M/E-1 to M/E-5, P/P) assignment in the Home > Setup > Switcher > Config > M/E Assign menu (19103.11).
b) If the number of keys on a single switcher bank is four or lower, SL keys can be used.
c) To use the cross-point box inputs, input signals must be assigned using the Home > Setup > Switcher > Box Settings > Re-Entry Source Assign menu
(19103.52).
d) When the system signal format is 720P, a format converter cannot be used.
e) To use the HDR converter function, the MZS-X1750 HDR Converter License (option) is required. When the system signal format is 720P, an HDR converter
cannot be used.
f) The number of outputs varies depending on the type of installed boards.
For details, see "Output numbers (2160P)" (page 513) and "Output numbers (other than 2160P)" (page 516) in "Input/Output Numbers."
g) To use the DME function, the MZS-X1610 3D DME License (option) is required. For 4K formats, either DMEs or SL keys can be enabled for each box.
h) To use the clip player function, the MZS-X1800 Clip Player License (option) is required.
i) In a multiple-box switcher configuration, you must configure a hardware block for use as a multi viewer or as a switcher bank.
For details, see "Setting a Switcher Bank/Multi Viewer" (page 366).