Setting NDCP (LSM)
You can configure the required setting using the ST 2110
routing function of LSM (Live System Manager).
Notes
• When the protocol is set to NMOS, NDCP(LSM)
cannot be configured.
• If no MKS-X1110 IP Input & Output Boards are
installed in the cross-point box or an M/E box
configured in a switcher, the menu will not be
displayed.
1
Open the Home > Setup > 100G IP I/F > Controller >
NDCP(LSM) menu (19108.14).
2
Select the target LAN port to set.
To select and set multiple LAN ports, place a check
mark beside the target LAN ports to set. To select and
set all LAN ports, place a check mark in the Select All
checkbox.
3
Check the DHCP setting state.
Enable: Obtain LSM address automatically using
DHCP is enabled.
Disable: Obtain LSM address automatically using
DHCP is disabled.
Note
Set to "Disable" (fixed).
4
Set the [LSM Enable] switch.
On: Use the port for control communication with
LSM.
Off: Do not use the port for control communication
with LSM.
Note
LAN port 1-1-1 is set to "On" (fixed), and "Enable"
is displayed.
5
Press the [LSM IP Address] button and enter an
address using the keyboard.
Note
Cannot be set when [LSM Enable] is turned off.
6
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
7
Check the message, then press [OK].
To check the LSM (Live System Manager) connection
status
You can check the LSM connection information for each
100G port using [Connection Status] in the Home > Setup
> 100G IP I/F > Controller > NDCP(LSM) menu
(19108.14).
Connected: Connected
Disconnected: Disconnected
Note
At least one 100G port on each box must be
connected.
455