Sony MKS-X1115 User Manual page 35

a Key delegation buttons
There are four key delegation buttons (1 to 4) in the order
top left, top right, bottom left, and bottom right.
You can assign keys of any switcher banks (M/E-1 to
M/E-5, P/P) in the Home > Setup > Panel > Module >
Button Assign menu (19104.21).
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 408).
b Independent key transition execution section
Fader lever
Transition indicator
Name Description
Fader lever Move this up or down to execute a
transition.
Transition indicator Displays the transition progress
using LEDs.
[KEY ON] button Inserts or removes a key
instantaneously.
When a key is currently inserted,
the button is lit amber.
[AUTO TRANS] Inserts or removes a key
button automatically with the set transition
rate and transition type.
During the transition, the button is
lit amber.
Note
The four [KEY ON] buttons and [AUTO TRANS]
buttons correspond to the keys assigned to key delegation
buttons 1 to 4.
The [KEY ON] button label indicates the key assigned to
the key delegation button.
c Independent key transition type selection buttons
Button name Description
MIX Selects mix.
WIPE Selects wipe.
KEY ON buttons
AUTO TRANS buttons
35
Button name Description
DME WIPE Selects DME wipe.
CUT Selects cut.
SHIFT Use when setting transitions separately for
key insertion and removal.
d Key snapshot operation buttons
Button name Description
K-SS 1 to Selects key snapshot register 1 to 4.
K-SS 4
K-SS Switches to key snapshot operation mode.
K-SS STORE Saves a key snapshot in the selected
register when a [K-SS 1] to [K-SS 4] button
is pressed while pressing the [K-SS
STORE] button.
UNDO Undoes a key snapshot recall if pressed
immediately after the recall.
e Display
Displays the following information for each key assigned
to a key delegation button.
• Key content name (key source name when a key source
is selected on a cross-point control block key bus)
• Currently used DME channel or resizer
• Transition rate
• Transition type
• Register name (in key snapshot operation mode).
For details about the content name display of keys, see
"Setting Logical V/K Pair Names/Source Names and
Destination Names" (page 422) and "Setting a Logical
V/K Pair" (page 386).