Table of Contents
Advertisement
To edit remote panel settings
Press the [Edit Panel Remote] button and edit the settings
in the [Panel Remote Settings] window.
1
Select the switcher to connect in [Processor to
Connect].
[Manual] radio button: Connect to specified
switcher. Press the [Default Gateway] and
[Remote IPv4 Address] buttons and enter a
default gateway address and the IPv4 address of
the switcher to connect, respectively, using the
keyboard.
[Off] radio button: Connect to a switcher on the
same network.
2
Press [OK].
To identify a control panel bank
Press the [Send Beacon] button in the [Panel] group to
cause the buttons in all control panel banks configured in
the selected control panel to flash for 5 seconds.
Press the [Send Beacon] button in the [Panel Bank] group
to cause the buttons in the selected control panel bank to
flash for 5 seconds.
Island Configuration
Configuring an island involves detecting devices,
assigning the devices to an island, and configuring the
devices.
The settings in the level 4 menus under MLS Manager
Home > System > Island are collectively reflected in the
MLS Manager Home > System > Island > Apply Config
menu (60211.12).
For details about reflecting the settings, see "Checking
and Applying an Island Configuration" (page 483).
Detecting Devices
You can detect devices (boxes and control panel banks) to
assign to an island.
Devices already assigned to an island and unassigned
devices can be detected.
The detected devices here are set as the target of
subsequent island settings.
Press the [Detect/Refresh] button in the MLS Manager
Home > System > Island > Detect Device menu
(60211.01) to display a list of the boxes and control panel
banks on the same network as MLS Manager.
The names displayed for the detected boxes will vary
depending on the input/output type.
For details about box input/output types, see "Displaying
Box Information" (page 369).
Status display
• If a device is detected successfully, the
displayed in [Status] in the MLS Manager Home >
System > Island > Detect Device menu (60211.01).
• If a device corresponding to the device configuration
information managed and saved by MLS Manager is
not detected, "---" is displayed in [Status] in the MLS
Manager Home > System > Island > Detect Device
menu (60211.01).
• If an item has unapplied settings, the
displayed in the list on each menu screen under MLS
Manager Home > System > Island. Apply the settings
and press the [Detect/Refresh] button in the MLS
Manager Home > System > Island > Detect Device
menu (60211.01) to run device detection again.
• If a device connection is not detected, the
displayed in the list on each menu screen under MLS
Manager Home > System > Island. Press the [Detect/
Refresh] button in the MLS Manager Home > System >
Island > Detect Device menu (60211.01) to run device
detection again.
• If an error occurs during device detection, the
is displayed in the list on each menu screen under MLS
475
icon is
icon is
icon is
icon
Advertisement
Table of Contents
