Table of Contents
Advertisement
To select and set multiple inputs, place a check mark
beside the target inputs to set.
To select and set all inputs, place a check mark in the
Select All checkbox.
3
Set the [Frame Synchronizer] switch to the on state.
To disable a frame synchronizer, set the [Frame
Synchronizer] switch to the off state.
Setting a Format Converter
You can use a format converter on odd-numbered inputs.
Note
When the system signal format is 720P, a format
converter cannot be used.
Setting the conversion format
You can set the signal format of an input signal to convert
by the format converter.
Notes
• Field frequency and frame frequency conversion is not
supported.
• If a conversion format that is different from the system
signal format is configured, the ancillary data will be
deleted.
• When receiving IP signals, adjacent ports may be
affected if the adjacent input ports are in the following
states.
– When a signal is input that is different from the input
format converter setting
– When the input format converter setting is changed
– When one input signal is disconnected while the same
signal source is being input
The following ports are affected, depending on the
signal format of the system.
– 2160P: Affected in units of 2 ports. [1ch-2ch]
[3ch-4ch] ... [143ch-144ch]
– 1080P, 1080i: Affected in units of 4 ports. [1ch-4ch]
[5ch-8ch] ... [157ch-160ch]
The signal formats that can be converted are given below.
System signal format
(frequency)
2160P 2SI
(59.94, 50)
1080P
(59.94, 50)
Signal format of input
signal
1080i
1080P
a)
2160P 2SI
b) c)
2160P 2SI 3G
b)
2160P 2SI 12G
720P
1080i
1080P
System signal format
(frequency)
1080i
(59.94, 50)
a) Configurable only for 100G IP input.
b) Configurable only for SDI input.
c) Only the first number input in each group of four odd-numbered inputs
(for example, the port numbers for input connectors 1, 3, 5, 7 are 1, 2, 3,
4) can be set. The settings of the inputs in each group are linked and
change accordingly.
1
Open the Home > Setup > System > Input > FC
Format menu (19101.32).
2
Select the target input to set.
To select and set multiple inputs, place a check mark
beside the target inputs to set.
To select and set all inputs, place a check mark in the
Select All checkbox.
3
Press the [FC Format] button and select an input
signal format from the pull-down list.
Adjusting the conversion method
The conversion method adjustment items and the target
conversion formats are given below.
Adjustment item
Up-converter
conversion mode
I/P converter
conversion mode
1
Open the Home > Setup > System > Input > FC
Adjust menu (19101.33).
2
Select the target input to set.
To select and set multiple inputs, place a check mark
beside the target inputs to set.
To select and set all inputs, place a check mark in the
Select All checkbox.
3
Adjust the conversion method.
To set the up-converter conversion mode
Press the [Conversion] button and select a conversion
mode from the pull-down list.
Frame: Conversion in frame units
Field: Conversion in field units
Adaptive: Detects motion in the signal, and
automatically switches mode between conversion in
frame units and field units.
When [Adaptive] is selected, press the [Motion] button
and enter a detection sensitivity (1 to 4) in the numeric
keypad window.
373
Signal format of input
signal
720P
1080i
Conversion format
• 1080i t 2160P
• 1080i t 1080P
Advertisement
Table of Contents
