Configuring Box Network Settings - Sony MKS-X1115 User Manual

Configuring Box Network Settings

You can configure the network settings of each box in an
island.
Setting the network interface
You can configure the following six types of network
interface for each box.
• Standard interface 1 (STD 1):
LAN 1 connector
( (see page 63) on rear of box) settings
d
• Standard interface 2 (STD 2):
LAN 2 connector
( (see page 63) on rear of box) settings
e
• Expansion interface 1 (OPT 1):
Network expansion 1 connector
( (see page 63) on rear of box) settings
p
• Expansion interface 2 (OPT 2):
Network expansion 2 connector
( (see page 63) on rear of box) settings
o
• Expansion interface 3 (OPT 3):
Network expansion 3 connector
( (see page 63) on rear of box) settings
n
• Expansion interface 4 (OPT 4):
Network expansion 4 connector
( (see page 63) on rear of box) settings
m
1) Can be used when a network card is installed in the PCIe slot of the box.
The box LAN connectors and configurable LAN types
supported by each network interface are shown below.
Network I/F Configurable LAN
STD 1 • Control LAN (Ctrl LAN)
STD 2 • Utility LAN 1 (Util LAN 1)
• No setting (Off)
OPT 1 • For control LAN
redundancy (Ctrl LAN
Redundant)
• No setting (Off)
OPT 2 • Utility LAN 2 (Util LAN 2)
• For utility LAN 1
redundancy (Util LAN 1
Redundant)
• No setting (Off)
OPT 3 • User LAN 1 (User LAN 1)
• No setting (Off)
OPT 4 • User LAN 2 (User LAN 2)
• For user LAN 1
redundancy (User LAN 1
Redundant)
• No setting (Off)
a) Number corresponding to the description of parts on the rear of the box.
1)
1)
1)
1)
a)
Connector
f
g
p
o
n
m
478
To set standard interface 1 (STD 1)
1
Open the MLS Manager Home > System > Island >
Box Network menu (60211.05).
2
In the [Network I/F] group list, select standard
interface 1 network interface of the target box to set.
Place a check mark for the target box network
interface to set (multiple selection supported).
Note
Multiple selection is supported only for LANs of the
same type (Ctrl LAN).
3
Press the [Edit Network I/F] button.
The [Standard Network I/F 1 Settings] window
appears.
Note
The standard interface 1 addresses can only be set
manually.
4
Press the [Address] button for [IPv4] and enter an
address using the keyboard.
Note
When multiple network interfaces are selected,
consecutively numbered IP addresses are set.
5
Press the [Prefix Length] button for [IPv4] and enter
a prefix length in the numeric keypad window.
Note
When multiple network interfaces are selected, the
same prefix length is set for all selected network
interfaces.
6
Press [OK].
To set an interface other than standard interface
1 (STD 1)
1
Open the MLS Manager Home > System > Island >
Box Network menu (60211.05).
2
In the [Network I/F] group list, select a network
interface other than standard interface 1 of the target
box to set.
Place a check mark for the target box network
interface to set (multiple selection supported).