Setting A Disk Recorder (Vdcp) - Sony MKS-X1115 User Manual

Item Item description
VTR Constant START DELAY (FRAME)
Block2 Byte2
VTR Constant AFTER SYNC DELAY –
Block2 Byte3
VTR Constant AFTER SYNC DELAY +
Block2 Byte4
VTR Constant MODE1
Block2 Byte5
VTR Constant MODE2
Block2 Byte6
VTR Constant MAX PRRL SPEED
Block2 Byte7
VTR Constant QUICK PVW PRRL TIME (FRAME)
Block2 Byte8

Setting a Disk Recorder (VDCP)

1
Open the Home > Setup > External Device > Serial/
Net Port Setting > DDR VDCP menu (19105.63).
A list of ports is shown on the left and the settings
status of the selected port is shown on the right.
2
In the list on the left, select the target port to set.
3
In the [DDR Type] group, select a type of disk
recorder.
Player: Player
Recorder: Recorder
4
In the [Name Mode] group, select a file name mode.
Fixed 8 Character: 8-character file name
Variable Length: Variable-length file name (up to
23 characters)
5
In the [Frame Control Mode] group, select a frame
control mode.
For a disk recorder that does not support a timecode
with a drop frame bit, set drop frame mode or non
drop frame mode.
Drop Frame: Drop frame mode
Non Drop Frame: Non-drop frame mode
Notes
• Configurable only when the system signal format
frequency is 59.94.
• If the drop frame bit of the timecode is set, it
operates in drop frame mode.
6
In the [TC Sense] group, select a timecode sense
mode.
Zero based: Timecode sense (detection), taking the
first frame of the loaded file as 00:00:00:00.
SOM based: Sense (detection) occurs using the
timecode recorded in the loaded file.
7
Enable/disable duration detection using the [Duration
Sense] button.
On: Enable duration sense (detection).
Off: Disable duration sense (detection).
8
In the list on the right, set the video port and response
speed of the item.
Press the [Setting] button for an item to set and enter
a setting in the numeric keypad window.
Item
Video Port
Maximum
Open Delay
Maximum
Cueup Delay
Play After
Cueup Delay
Stop Delay
Still Delay
Continue Delay Delay time from issuing the Continue
Idle Delay
Status Sense
Interval
Internal
Parameter (1)
to (10)
Setting loop/recue
You can enable/disable looping and recueing.
1
Open the Home > Setup > External Device > Serial/
Net Port Setting > DDR VDCP menu (19105.63).
2
Enable/disable looping using the [Loop] button.
On: Enable looping. Replay the loaded file in a
continuous loop.
Off: Disable looping.
437
Item description
Number of the video port associated
with the target port to set
• Output port setting for a player
• Input port setting for a recorder
Maximum time required to open a file
Maximum time required to cueup a
file
Delay time after cueup until playback
starts
Delay time from issuing the Stop
command until playback stops
Delay time from issuing the Still
command until playback stops
command until playback stops
Time from when file unload is
executed until idle state occurs.
The idle state is a state wherein a
previous file has been unloaded
before a new file is loaded (state
where no file has been loaded).
Time until the next Status Sense
command is issued
Reserved for future use.
Set the value to "255".