Sony MKS-X1115 User Manual page 226

– Press the [RUN] button to play to a point close to the
end of a file t stop playback t press the [RUN]
button again.
Perform the following operation if playback freezes.
– Recall another register t recall the target register t
press the [REWIND] button t press the [RUN]
button.
• Some operating limitations apply when the video disk
communications protocol is used.
These are explained with reference to the following
figure, which illustrates creation of a timeline that plays
from the video of file A to the video of file B.
– With the following settings, black video or still image
appears momentarily when playback switches from
file A to file B:
KF1 action Status of file A
Start Playback
Start Playback
Variable Speed Playback at
variable speed
Cueup Cueup
– Some actions may not operate with the following
settings.
KF1 action Status of file A
Start Playback
Variable Speed Playback at
variable speed
Cueup Cueup
Does not operate when KF2 variable speed is set to a
negative value. It does operate when the file B action
is set to "Start" and then variable speed is set to a
negative value after file B starts playing.
– With the following settings, switching from file A to
file B does not occur.
KF1 action Status of file A
Variable Speed Playback at
variable speed
Cueup Cueup
If playback continues to show video of file A without
switching to file B, a "Stop" action is required for file
A in order to switch to file B.
• Loop/recue cannot be set on a timeline for the video
disk communications protocol.
• When using the Odetics protocol, the variable speed
action may not operate, depending on the connected
device.
• Folder selection cannot be set on a timeline for the
AMP protocol.
Setting an action
You can configure an action at a keyframe point on an
effect timeline.
For details about setting an effect timeline, see "Effect
Timeline Operations (Menu)" (page 265).
For a disk recorder, the target file must be loaded.
For details about loading a file, see "Disk Recorder File
Operations" (page 227).
Notes
• Up to eight files can be configured for a single effect
timeline.
• If you have not configured a file, the file loaded at the
KF2 action keyframe point when the effect timeline is executed
becomes the target of the action.
Start
• AMP protocol folder selection cannot be set on an
Cueup
effect timeline. The folder loaded at the keyframe point
Cueup
when an effect timeline is executed becomes the target
of the action.
Cueup
1
KF2 action
Variable Speed
2
Variable Speed
3
Variable Speed
KF2 action
Start
Start
4
226
Open the Home > External Device > Device >
Timeline > Action menu (16101.41).
DDR/VTR timeline settings information is displayed
for each device channel number (1 to 12).
Select the target device for operation.
In the [Action] group, select an action to set.
Cueup: Set a cueup action.
Start: Set a start action.
Stop: Set a stop action.
Notes
• When both a stop point and variable speed are set
for a start action, the variable speed setting takes
priority.
• When a stop point timecode or the disk recorder
end-of-file is reached before executing a stop
action, operation stops at that point.
• When a start point is not set for a cueup action for a
disk recorder, set cueup to the start of the file.
Press the left button in the [Start TC] group and enter
a start point timecode in the numeric keypad window.