Setting The Video Clip Function; Setting The Safe Title Area; Setting A Format Converter - Sony MKS-X1115 User Manual

• When MKS-X1110 IP Input & Output Boards are
installed, ancillary data is deleted from the signals on
inputs 1 and multiples of 4 + 1 (1, 5, 9, and so on).
• In a 1M/E box switcher configuration, ancillary data is
deleted in the following cases.
• When signals on ports on slot 1 are output from ports
on slot 4
• When signals on ports on slot 4 are output from ports
on slot 1
For details about the relationship between slots and
input/output port numbers, see "Input/Output
Numbers" (page 511).
1
Open the Home > Setup > System > Output > Output
Assign menu (19101.41).
2
Select the target output to set.
To select and set multiple outputs, place a check mark
beside the target outputs to set.
To select and set all outputs, place a check mark in the
Select All checkbox.
3
Enable/disable through mode using the [Through
Mode] switch.
On: Enable through mode.
Off: Disable through mode.

Setting the Video Clip Function

1
Open the Home > Setup > System > Output > Video
Adjust menu (19101.42).
2
Select a tab to switch the target to set.
[Output] tab: Output video clip settings
[Dedicated Out] tab: Dedicated output video clip
settings
3
Select the target output to set and set the following
parameters.
No. Parameter
1 White Clip
2 Dark Clip
3 Chroma Clip
To return the settings to the defaults
Press the [Reset] button.
Adjustment
Luminance signal white clip
value
Luminance signal dark clip
value
Chrominance signal clip value

Setting the Safe Title Area

1
Open the Home > Setup > System > Output > Safe
Title menu (19101.43).
2
Select a tab to switch the target to set.
[Output] tab: Output safe title settings
[Dedicated Out] tab: Dedicated output safe title
settings
3
Select the target output to set.
4
Set the safe title area display method.
To display box 1
Set the [Box1] button to the on state.
Set the following parameter.
No. Parameter
1 Size
In the [Box1 Adjust] group, select an aspect ratio
(16:9, 14:9, 4:3).
To display box 2
Set the [Box2] button to the on state.
Set the following parameters.
No. Parameter
1 Size
2 Luminance
In the [Box2 Adjust] group, select an aspect ratio
(16:9, 14:9, 4:3).
To display a cross
Set the [Cross] button to the on state.
To display a grid
Set the [Grid] button to the on state.
In the [Grid Adjust] group, select an aspect ratio
(16:9, 4:3).
In the [Grid Size] group, select a size (80.00%,
85.00%, 90.00%, 100.00%).
To return the settings to the defaults
Press the [Reset] button.

Setting a Format Converter

You can convert the signal format of an output signal.
You can use a format converter on odd-numbered
outputs.
379
Adjustment
Size
Adjustment
Size
Luminance