Table of Contents
Advertisement
4
Press the [Color] button and select a color space from
the pull-down list.
Select [BT.709] or [BT.2020].
5
Enable/disable the system settings using the [Follow
System Settings] switch.
On: Enable system settings. Apply the system
settings to the input signal.
Off: Disable system settings. Apply different settings
than the system settings to the input signal.
If the system settings are disabled, press the [Adjust
Details] button and configure the HDR conversion
settings in the [HDR Converter] window.
Note
When multiple inputs are selected, the [Follow
System Settings] switch settings do not change in
unison.
[HDR Converter] window > [Config] tab
Sets the HDR conversion mode.
1
In the [Conversion Mode] group, select a conversion
mode.
Select [AIR Matching On], [AIR Matching Off], or
[Display Referred].
2
Press the [HDR Look] button and select a type of look
from the pull-down list.
Select [Live], [Mild], or [Natural].
Notes
• When the input signal OETF is set to [PQ], [S-Log3
(HDR)], or [S-Log3 (Live HDR)], [Natural] cannot
be selected.
• This cannot be set when the input signal OETF is
set to [SDR].
• This cannot be set when the [Look Conversion]
button is set to the on state on the [Additional Paint]
tab.
3
Enable/disable the black compression function using
the [HDR Black Comp.] button.
Note
This cannot be set when the [Look Conversion]
button is set to the on state on the [Additional Paint]
tab.
4
In the [Black Level] group, set the black level.
For a Sony system camera input signal
Press the [Sony System Camera] button.
Press the [Master Black (Abs.)] button and enter a
master black value in the numeric keypad window.
Press the [HDR Black Offset] button and enter an
HDR black offset in the numeric keypad window.
For a non-Sony system camera input signal
Press the [Others] button.
Press the [Master Black (HDR)] button and enter an
HDR black level in the numeric keypad window.
Press the [Master Black (SDR)] button and enter an
SDR black level in the numeric keypad window.
Notes
• When the system OETF and input signal OETF are
set to [SDR], [Black Level (HDR)] cannot be set.
• When the system OETF and input signal OETF are
set to [HLG], [PQ], [S-Log3 (HDR)], or [S-Log3
(Live HDR)], [Black Level (SDR)] cannot be set.
[HDR Converter] window > [Conversion]
tab
Sets the mode for conversion from HDR to HDR, SDR to
HDR, or HDR to SDR.
Note
This cannot be set when the system OETF and input
signal OETF are set to [SDR].
When converting from HDR to HDR
Enable/disable the black clip function using the [HDR
Black Clip] button.
On: Enable the black clip function.
Off: Disable the black clip function.
Note
This cannot be set when the system OETF is set to
[S-Log3 (HDR)] or [S-Log3 (Live HDR)].
When converting from SDR to HDR
1
Enable/disable the highlight creation function using
the [Highlight Creation] button.
On: Enable the highlight creation function.
Press the [Point (Abs.)] button and select a knee
point position for the curve from the pull-down
list.
Press the [Slope (Abs.)] button and select a slope
for the curve from the pull-down list.
Off: Disable the highlight creation function.
375
Advertisement
Table of Contents
