To set consecutive addresses, select multiple buttons
and enter an address.
Consecutive addresses starting from the entered
number are configured.
Notes
• When consecutive multiple buttons are selected
and consecutive addresses are configured, the
maximum value of the set range will be duplicated
if the configuration range is exceeded.
• Cannot be configured when [Hitless Failover] is
turned off in the Home > Setup > System > 100G IP
Input/Output > Config menu (19101.52).
7
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
8
Check the message, then press [OK].
Setting the Audio Format
You can configure the audio format for each input and
output of boxes configured in a switcher.
For details about input/output numbers, see "Input/
Output Numbers" (page 511).
Note
Configurable only for ports 1 and multiples of 4 + 1 (1, 5,
9, and so on).
1
Open the Home > Setup > System > 100G IP Input/
Output > Audio Format menu (19101.55).
2
Select a tab to switch the target to set.
[Input] tab: Input audio format settings
[Output] tab: Output audio format settings
3
Select the target button to set.
To select and set multiple buttons, place a check mark
beside the target buttons to set.
To select and set all buttons, place a check mark in the
Select All checkbox.
4
Press the [Audio Format] button and select an audio
format for each input from the pull-down list.
The following audio formats can be selected.
48kHz/0.125ms/2ch
48kHz/0.125ms/4ch
48kHz/0.125ms/8ch
48kHz/0.125ms/16ch
48kHz/1ms/2ch
48kHz/1ms/4ch
48kHz/1ms/8ch
5
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
6
Check the message, then press [OK].
383