Table of Contents
Advertisement
1-3. Setting after Installation
Install the supplied application software "e-VTR Manager" on a personal computer (PC) meeting the
following requirements.
"e-VTR Manager" may not perform normally if installed on a PC that does not meet these requirements.
OS:
Microsoft Windows XP
Microsoft Windows 2000
Web browser:
Netscape (Ver. 6 or later)
Internet Explorer (Ver. 5 or later)
DirectX:
8.1b or later
CPU:
1 GHz or higher
Memory:
256 MB or more
Hard disk:
Available space 5 MB or more
Drive:
CD-ROM
Display:
Recommended XGA (1024 x 768) or more
Windows, Windows XP, and Internet Explorer are registered trademarks of Microsoft Corporation.
Netscape is a registered trademark of Netscape Communications Corporation.
1-3-1. Network Setting
Network enable switch
REMOTE
POWER
NETWORK
1 (9P)
2 (50P)
PHONES
DISPLAY
FULL/FINE
1. Check that no cable is connected to the Ethernet connector of the connector panel.
n
If the following steps are performed with the LAN cable connected, the network setting is not
incorporated to the VTR correctly.
2. Activate the maintenance mode. (Refer to Section 1-1-1.)
3. Turn the MULTI CONTROL knob to display "M5 : NETWORK" in the menu display area.
4. Press the F5 (SET) button.
. On pressing it, "M50 : IP ADDRESS" is displayed.
1-18 (E)
RS-232C
EJECT
ASSEMBLE
VIDEO
TC
VIUB
DF LTC VITC
01:23:45:06
CHANNEL
SET
MO : CHECK
CONDITION
UP
HOME
F1
HOME button
SHIFT
Menu display area
indicator
INSERT
CH1
CH2
CH3
CH4
CH5
CH6
CH7
2F
59.94
CONFI
ON
DOLBY NR
IMX
525
TOTL:01:23:05
78. 9%
SET
EXIT
F2
F3
F4
F5
F6
F5 (SET)
F6 (EXIT)
button
button
MULTI CONTROL knob
MULTI
RECORDER
CONTROL
CH8
PLAYER
PUSH/
SHIFT
ARARM
KEY INHI
RESET
SHUTTLE/VAR
JOG
BKMW-E3000
Advertisement
Table of Contents
