Table of Contents
Advertisement
4
Enter an effect duration in the numeric keypad area in
the numeric keypad control block.
Enter a duration as a timecode
(minute:second:frame).
Note
You can also enter a difference value from the
currently set value using the [TRIM] button.
For details, see "Entering a difference from a current
value" (page 81).
5
Press the [ENTER] button.
The effect duration is applied.
Setting the keyframe duration
Notes
• In constant duration mode, it is not possible to set the
keyframe duration.
• You can set a default value for the keyframe duration.
For details about settings, see "Setting the default
keyframe duration" (page 427).
1
Press the [KF MCRO EDIT] button.
The memory recall section switches to effect
timeline/macro edit mode.
2
Press the [EDIT ENBL] button, turning it on orange.
3
Select an edit point (keyframe).
The time from the selected keyframe to the following
keyframe is the target to set.
4
Press the [KF DUR] button.
"KF DUR XXX:XX" ("XXX:XX" is the current
keyframe duration) is displayed on the display in the
numeric keypad control block.
5
Enter a keyframe duration in the numeric keypad area
in the numeric keypad control block.
Enter a duration as a timecode (second:frame).
Note
You can also enter a difference value from the
currently set value using the [TRIM] button.
For details, see "Entering a difference from a current
value" (page 81).
6
Press the [ENTER] button.
The keyframe duration is applied.
Setting the delay
1
Press the [KF MCRO EDIT] button.
The memory recall section switches to effect
timeline/macro edit mode.
2
Press the [EDIT ENBL] button, turning it on orange.
3
Press the [DELAY] button.
"DELAY XXX:XX" ("XXX:XX" is the current
delay) is displayed on the display in the numeric
keypad control block.
4
Enter a delay in the numeric keypad area in the
numeric keypad control block.
Enter a delay as a timecode (second:frame).
Note
You can also enter a difference value from the
currently set value using the [TRIM] button.
For details, see "Entering a difference from a current
value" (page 81).
5
Press the [ENTER] button.
The delay is applied.
264
Advertisement
Table of Contents
