Table of Contents
Advertisement
The following modifiers can be set separately for the
main pattern and sub pattern.
Modifiers for the main pattern are set in the Main Modify
menu, and modifiers for the sub pattern are set in the Sub
Modify menu.
• Position
• Rotation
• Aspect
• Multiplication
• Pairing
• Modulation
• Spring
• Spiral
This section describes the menu for setting modifiers for
the main pattern as an example.
Setting the wipe direction (Direction)
Set the direction of travel of the wipe.
Normal
Wipe in the normal direction.
Reverse
Wipe in the opposite direction of the normal direction.
Normal/Reverse
Alternate directions between normal and reverse after
each transition.
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Pattern Mix/Edge/Direction menu (11109.33).
2
In the [Direction] group, select a wipe direction.
To set the wipe direction using buttons in the
transition control block
You can set the wipe direction using the transition control
block/transition control block (simple type) of the target
switcher bank.
Note
The buttons used for configuring the wipe direction must
be assigned to the transition control block/transition
control block (simple type) beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 408).
On the transition control block, use the following wipe
direction selection buttons.
[NORM] button: Normal
[NORM/REV] button: Normal/Reverse
[REV] button: Reverse
On the transition control block (simple type), use the
following wipe direction selection buttons.
[NORM/REV] button: Normal/Reverse
[REV] button (when not lit): Normal
[REV] button (when lit): Reverse
Splitting a wipe pattern (Split)
You can split a wipe pattern, making the parts of the wipe
move in opposite directions.
Split disabled
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Pattern Mix/Edge/Direction menu (11109.33).
2
Set the [Split] button to the on state and set the
following parameters.
No.
Parameter
1
Split No.
2
Spacing
Modifying a wipe pattern edge (Edge)
Border
Adds a border to a pattern.
Soft
Softens the edges of a pattern.
155
Split enabled
Adjustment
Number of splits (1 to 4)
Spacing between adjacent
patterns
Advertisement
Table of Contents
