Configuring A Device (Off-Island); Configuring Box Network Settings - Sony MKS-X1115 User Manual

Configuring a Device
(Off-Island)
You can configure the settings for boxes that are not
assigned to an island and for control panel banks that are
not configured in a control panel.
Status display
• If an item has unapplied settings, the
displayed in the list on each menu screen under MLS
Manager Home > System > Off-Island. Apply the
settings and press the [Detect/Refresh] button to run
device detection again.
• If a device connection is not detected, the
displayed in the list on each menu screen under MLS
Manager Home > System > Off-Island. Press the
[Detect/Refresh] button to run device detection again.

Configuring Box Network Settings

You can configure the network settings of boxes that are
not assigned to an island.
Setting the network interface
You can configure the following six types of network
interface for each box.
• Standard interface 1 (STD 1):
LAN 1 connector
( (see page 63) on rear of box) settings
d
• Standard interface 2 (STD 2):
LAN 2 connector
( (see page 63) on rear of box) settings
e
• Expansion interface 1 (OPT 1):
Network expansion 1 connector
( (see page 63) on rear of box) settings
p
• Expansion interface 2 (OPT 2):
Network expansion 2 connector
( (see page 63) on rear of box) settings
o
• Expansion interface 3 (OPT 3):
Network expansion 3 connector
( (see page 63) on rear of box) settings
n
• Expansion interface 4 (OPT 4):
Network expansion 4 connector
( (see page 63) on rear of box) settings
m
1) Can be used when a network card is installed in the PCIe slot of the box.
icon is
icon is
1)
1)
1)
1)
484
The box LAN connectors and configurable LAN types
supported by each network interface are shown below.
Network I/F Configurable LAN
STD 1 • Control LAN (Ctrl LAN)
STD 2 • Utility LAN 1 (Util LAN 1)
• No setting (Off)
OPT 1 • For control LAN
redundancy (Ctrl LAN
Redundant)
• No setting (Off)
OPT 2 • Utility LAN 2 (Util LAN 2)
• For utility LAN 1
redundancy (Util LAN 1
Redundant)
• No setting (Off)
OPT 3 • User LAN 1 (User LAN 1)
• No setting (Off)
OPT 4 • User LAN 2 (User LAN 2)
• For user LAN 1
redundancy (User LAN 1
Redundant)
• No setting (Off)
a) Number corresponding to the description of parts on the rear of the box.
To set standard interface 1 (STD 1)
1
Open the MLS Manager Home > System > Off-Island
> Box Network menu (60219.01).
2
Press the [Detect/Refresh] button.
The network interfaces of boxes on the same network
as MLS Manager and are not assigned to an island are
detected.
Note
If no connections with boxes corresponding to the
network interface are detected, the
displayed. Press the [Detect/Refresh] button to run
network interface detection again.
3
In the [Network I/F] group list, select standard
interface 1 network interface of the target box to set.
Place a check mark for the target box network
interface to set (multiple selection supported).
Note
Multiple selection is supported only for LANs of the
same type (Ctrl LAN).
4
Press the [Edit Network I/F] button.
The [Standard Network I/F 1 Settings] window
appears.
a)
Connector
f
g
p
o
n
m
icon is