Table of Contents
Advertisement
Preparations
For Using a Computer
Install e-VTR Manager on a computer meeting the
following requirements.
e-VTR Manager may not perform normally if installed
on a computer that does not meet these requirements.
CPU: 500 MHz or higher
Memory: 128 MB or greater
OS: Windows XP/NT/2000/98 (Second Edition)
Language: English
Basic Network Settings
Use the VTR maintenance menu to make basic
network settings.
Use the following procedure to set the IP address,
subnet mask, and default gateway.
1
With the HOME pressed, press the F5 (MENU)
button to open the maintenance menu page.
MAINTENANCE MODE
M0 : CHECK
M1 : ADJUST
M2 : ERROR LOGGER
M3 : OTHERS
M4 : SETUP MAINTENANCE
2
On the VTR control panel, display the HOME
page of the function menu.
3
Rotate the MULTI CONTROL knob to bring the
cursor to M3: OTHERS and press the F5 (SET)
button.
4
Rotate the MULTI CONTROL knob to bring the
cursor to M3B: NETWORK and press the F5
(SET) button.
6
5
Rotate the MULTI CONTROL knob to bring the
cursor to the item you want to set and press the F5
(SET) button.
To set the IP address
Bring the cursor to M3B0: IP ADDRESS.
To set the subnet mask
Bring the cursor to M3B1: SUBNET MASK.
To set the default gateway
Bring the cursor to M3B2: DEFAULT
GATEWAY.
6
Enter a new value or change the present value.
To bring the cursor to the value you want to
change
Rotate the MULTI CONTROL knob.
To change a value
Rotate the MULTI CONTROL knob while holding
the HOME button down.
7
When you have set the value, press the F5 (SET)
button.
The message "Save Complete" appears.
Checking the state of the network
The network indicator lights or goes out as follows,
according to the state of the network.
Not lit: No FTP connection
Lit: FTP connection
Network Enable Switch
Full access to the network is possible when the
network enable switch is lit. When the network enable
switch is not lit, limited network access is permitted
for the functions indicated below.
• Access via link layer (ping response, etc.)
• Web browsing (setting changes not permitted)
• SNMP (acquisition of maintenance data permitted)
• SMTP (mail messages can be sent)
Advertisement
Table of Contents
