Table of Contents
Advertisement
4
Press the [MOD] button.
The selected event is modified.
Note
You can also select and modify all events.
For details, see "Selecting all events" (page 312).
Deleting an event
1
Select an edit point.
2
Press the [DEL] button.
The selected event is deleted.
Note
You can also select and delete all events.
For details, see "Selecting all events" (page 312).
Selecting all events
To select all events registered in a macro as edit targets,
press the [ALL] button, turning it on orange.
This operation is available when modifying or deleting an
event.
Merging registers
You can insert all events from another register at a
specified position.
1
Select an edit point.
2
Enable auto insert mode.
Note
Registers cannot be merged when auto insert mode is
disabled.
3
Recall a register to merge.
Recall a macro register using one of the following
buttons.
• Buttons with a set macro attachment (see page 329)
• Cross-point buttons in the cross-point control block
(see page 322)
• Buttons in cross-point pad in the cross-point control
block/AUX bus control block (see page 322)
• Memory recall buttons in the utility/shotbox
control block (see page 322)
• Memory recall buttons in the utility control block
(see page 322)
• Buttons in the numeric keypad area in the numeric
keypad control block (see page 323)
All events in the recalled register are inserted after the
selected event.
312
Advertisement
Table of Contents
