Table of Contents
Advertisement
When not using the IPv4 default gateway, select [No
Assign].
The [Mode] setting for [IPv4] is linked to the selected
LAN setting. When set to [Off] or [DHCP], proceed
to step 6.
5
Press the [Address] button for [IPv4] and enter an
address using the keyboard.
6
Press the [LAN] button for [IPv6] and select the
target LAN to set from the pull-down list.
Select [Util LAN 1], [Util LAN 2], [User LAN 1], or
[User LAN 2].
When not using the IPv6 default gateway, select [No
Assign].
The [Mode] setting for [IPv6] is linked to the selected
LAN setting. When set to [Off], [Auto], or [DHCP],
proceed to step 8.
7
Press the [Address] button for [IPv6] and enter an
address using the keyboard.
8
Press [OK].
Setting the DNS server of a box
1
Open the MLS Manager Home > System > Island >
Box Network menu (60211.05).
2
In the [Box] group list, select the target box to set.
3
Press the [Edit DNS Server] button.
The [DNS Server Settings] window appears.
4
Press the [Mode] button and select a setup mode from
the pull-down list.
Off: Do not use a DNS server.
Manual: Set manually.
DHCP: Set automatically using DHCP.
When [Manual] is selected, proceed to step 6.
When [Off] is selected, proceed to step 8.
Note
If there is no LAN with network interface setup mode
set to DHCP on the target box, [DHCP] cannot be
selected.
5
Select a LAN for obtaining DNS in [LAN].
Press the button on the left and select a LAN from the
pull-down list, then press the button on the right and
select IPv4 or IPv6 from the pull-down list.
Proceed to step 8.
Note
LANs that are set to a network interface setup mode
other than DHCP cannot be selected.
6
Press the [Domain Name] button and enter a domain
name using the keyboard.
7
Press a [Server 1] to [Server 4] button and enter a
server address using the keyboard.
Enter an IPv4 address or IPv6 address.
8
Press [OK].
To identify a box
Select the target box from the [Box] group list and press
the [Send Beacon] button to cause the front panel LED
bars on the selected box to flash for 5 seconds.
Configuring 100G IP Network
Settings
You can configure the network settings of the 100G IP
interfaces of each box in an island that has MKS-X1110
IP Input & Output Boards installed for input/output.
Each box in an island that has MKS-X1110 IP Input &
Output Boards installed for input/output is equipped with
eight 100G IP ports (M/E box) or four 100G IP ports
(cross-point box). Ports for Slot/LAN with suffix of "-1"
are used for the ST 2110 transmission primary network,
and ports for Slot/LAN with suffix of "-2" are used for the
secondary network. You can configure the following
network settings of each port.
• FEC type
• IPv4 IP address/prefix length
• Gateway
1
Open the MLS Manager Home > System > Island >
100G IP Network menu (60211.06).
2
Select the target LAN port to set.
Place a check mark for the target LAN port to set
(multiple selection supported).
To select and set all LAN ports, place a check mark
in the Select All checkbox.
3
Press the [FEC] button and select an FEC type.
RS-FEC: Use Reed-Solomon FEC (CL91).
None: Do not use FEC.
Note
When multiple LAN ports are selected, the same FEC
type is set on all ports.
480
Advertisement
Table of Contents
