Sony MKS-X1115 User Manual page 418

a)
Function name Cross-point
button
number
Row-n Xpt Btn 298
No.298
Row-n Xpt Btn 299
No.299
Row-n Xpt Btn 300
No.300
a) "Row-n" is Row-1 to Row-4.
Setting the home page
You can set the page to display when the [HOME] button
in a cross-point pad is pressed.
1
Open the Home > Setup > Panel > Xpt Module > Xpt
Pad Button Assign menu (19104.36).
2
In the [Select Bank] group, select the target switcher
bank/AUX bus control block (AUX 1, AUX 2) to set.
Place a check mark for the switcher bank/AUX bus
control block to select.
You can also select and set multiple switcher banks or
AUX bus control blocks simultaneously.
Notes
• A switcher bank and AUX bus control block cannot
be selected simultaneously.
• In multi program 2 mode, main and sub can be set
separately. When a switcher bank main and sub are
shared, the setting is also shared.
3
Display the page you want to set as the home page.
Select a tab to change the page (Page 1 to Page 14) to
display.
4
Set the [Home Page Enable] switch to the on state.
The selected page is set as the home page.
Changing the button image for the control
panel button display
The names of functions assigned to buttons are displayed
in the button image in [Button Assign].
You can change the button image display to the color and
name of buttons in the cross-point pad in the control
panel.
Notes
• The button image display settings are common to all
pages in the cross-point pad.
• The display of a button status (lit/not lit), white frame
for buttons configured with page recall function, and
Logical Signal
V/K pair
number
249 M/E-5 Out5
284 (black signal)
284 (black signal)
418
current status are not reflected in the [Button Assign]
button image. The button name displayed in the control
panel may vary depending on the button.
1
Open the Home > Setup > Panel > Xpt Module > Xpt
Pad Button Assign menu (19104.36).
2
In the [Select Bank] group, select the target switcher
bank/AUX bus control block (AUX 1, AUX 2) to set.
Place a check mark for the switcher bank/AUX bus
control block to select.
You can also select and set multiple switcher banks or
AUX bus control blocks simultaneously.
Notes
• A switcher bank and AUX bus control block cannot
be selected simultaneously.
• In multi program 2 mode, main and sub can be set
separately. When a switcher bank main and sub are
shared, the setting is also shared.
3
Set the [Button Reference Image] switch to the on
state.
Returning cross-point pad settings to the
defaults
1
Open the Home > Setup > Panel > Xpt Module > Xpt
Pad Button Assign menu (19104.36).
2
In the [Select Bank] group, select the target switcher
bank/AUX bus control block (AUX 1, AUX 2) to set.
Place a check mark for the switcher bank/AUX bus
control block to select.
You can also select and set multiple switcher banks or
AUX bus control blocks simultaneously.
Notes
• A switcher bank and AUX bus control block cannot
be selected simultaneously.
• In multi program 2 mode, main and sub can be set
separately. When a switcher bank main and sub are
shared, the setting is also shared.
3
Press the [Default Recall] button.
4
Check the message, then press [OK].
The settings of the cross-point pad on the selected
switcher bank/AUX bus control block are returned to
the defaults.