Sony MKS-X1115 User Manual page 493

Setting a community
Note
The following community names are set by default.
To prevent security risks, we recommend changing the
community names from the default values.
Read-Only Community: public
Read-Write Community: private
Trap Community: unknown
1
Open the MLS Manager Home > SNMP > v1/v2c
Community menu (64101.02).
2
Press the [Read-Only Community] button for
[Community Name] and enter an MIB read-only
community name (up to 255 characters) using the
keyboard.
3
Press the [Read-Write Community] button for
[Community Name] and enter an MIB read/write
community name (up to 255 characters) using the
keyboard.
4
Press the [Trap Community] button for [Community
Name] and enter a community name (up to 255
characters) to add when sending a trap using the
keyboard.
5
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then
press [OK].
6
Check the message, then press [OK].
Configuring a host
1
Open the MLS Manager Home > SNMP > v1/v2c
Hosts menu (64101.03).
2
Press an [Address 1] to [Address 3] button for [SNMP
v1/v2c Communication Hosts] and enter an SNMP
manager allowed to connect using the keyboard.
You can enter an IPv4 address, IPv6 address, or
FQDN (fully qualified domain name) for the SNMP
manager, or a network IPv4 address or IPv6 address.
3
Press an [Address 1] to [Address 3] button for [SNMP
v1/v2c Trap Hosts] and enter a destination SNMP
manager to send traps using the keyboard.
You can enter an IPv4 address, IPv6 address, or
FQDN (fully qualified domain name) for the SNMP
manager.
4
Press the [Apply] button.
If there are any blank fields or the same address has
been entered more than once, the following
configuration occurs.
SNMP v1/v2c Communication Hosts:
• If one of the [Address 1] to [Address 3] buttons is
blank, the settings of the buttons move down to the
lower number buttons.
• If all of the [Address 1] to [Address 3] buttons are
blank, the default value (127.0.0.1) is configured
for the [Address 1] button.
• If the same address is configured in successive
fields of the [Address 1] to [Address 3] buttons, the
setting of the button with the lowest number is
retained and the duplicate is removed. For example,
if the same address is configured for the
[Address 1] button and [Address 2] button, that
address is configured for the [Address 1] button.
However, if the same address is configured for the
[Address 1] button and [Address 3] button with a
different address for the [Address 2] button, the
address configuration does not change because the
duplicate addresses are not consecutive.
SNMP v1/v2c Trap Hosts:
If one of the [Address 1] to [Address 3] buttons is
blank, the settings of the buttons move down to the
lower number buttons.
To return to the previous setting
Press the [Clear] button, check the message, then
press [OK].
5
Check the message, then press [OK].
To send a test trap
Press the [Send Test Trap] button.
493