Table of Contents
Advertisement
100G IP I/F Setup
Displaying 100G IP I/F
Setup Information
You can check the status information of each LAN port of
the 100G IP interface using the Home > Setup > 100G IP
I/F > Status menu (19108.11).
The following information is displayed.
FEC Type/Link Status: FEC type/link status
IP Address/Prefix Length: IP address/prefix length
Gateway: Gateway
Mac Address: MAC address
Notes
• Setup information displayed using this menu cannot be
changed.
For details, refer to the MLS Manager manual.
• If no MKS-X1110 IP Input & Output Boards are
installed in the cross-point box or an M/E box
configured in a switcher, the menu will not be
displayed.
Chapter
Setting the Control
Protocol
You can set the control communications protocol for ST
2110 transmission connections. Each box configured in a
switcher using MLS manager communicates with the
controller independently using the selected protocol.
Note
If no MKS-X1110 IP Input & Output Boards are installed
in the cross-point box or an M/E box configured in a
switcher, the menu will not be displayed.
1
Open the Home > Setup > 100G IP I/F > Controller >
Protocol menu (19108.12).
2
In the [Protocol] group, select the protocol.
NMOS: NMOS
NDCP(LSM): NDCP
3
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
4
Check the message, then press [OK].
Setting the node label
You can set the device name exposed to the controller for
NMOS/NDCP(LSM).
1
Open the Home > Setup > 100G IP I/F > Controller >
Protocol menu (19108.12).
2
Press the [Node Label] button and enter the RDS
node name (up to 59 characters) using the keyboard.
452
28
Advertisement
Table of Contents
