Table of Contents
Advertisement
4
Press the [IP Address] button and enter an address
using the keyboard.
Notes
• When multiple LAN ports are selected,
consecutively numbered IP addresses are set.
• When setting consecutive IP addresses, set the
prefix length beforehand to avoid setting an IP
address the same as the network address or
broadcast address.
5
Press the [Prefix Length] button and enter a prefix
length in the numeric keypad window.
Note
When multiple LAN ports are selected, the same
prefix length is set.
6
Press the [Gateway] button and enter an address using
the keyboard.
Note
When multiple LAN ports are selected, the same
gateway is set.
To identify the box corresponding to a LAN port
Select the target LAN port and press the [Send Beacon]
button to cause the front panel LED bars on the box
corresponding to the selected LAN port to flash for
5 seconds.
Configuring Control Panel Network
Settings
You can configure the network settings of a control panel
that is assigned to a switcher in an island and of the
control panel banks configured in the control panel.
For details about configuring the network settings of a
control panel not assigned to a switcher in an island, see
"Configuring Control Panel Network Settings"
(page 474).
For details about configuring the network settings of
control panel banks not configured in a control panel, see
"Configuring Control Panel Bank Network Settings"
(page 488).
1
Open the MLS Manager Home > System > Island >
Panel Network menu (60211.07).
2
In the [Panel] group list, select the target control
panel to set.
3
In the [Panel Bank] group, select [All] or [Selected].
All: Displays the control panel banks configured in
all the control panels displayed in the list in the
[Panel] group.
Selected: Displays the control panel banks
configured in the control panel selected in the list
in the [Panel] group.
4
In the [Panel Bank] group, select the target control
panel bank to set.
Place a check mark for the target control panel bank
to set (multiple selection supported).
To select and set all control panel banks, place a
check mark in the Select All checkbox.
5
Press the [Edit Panel Bank] button.
A setup window for the selected control panel bank
appears.
6
Press the [Hostname] button and enter a host name
(up to 63 characters) using the keyboard.
Note
Cannot be configured when multiple control panel
banks are selected.
7
Press the [Address] button for [IPv4] and enter an
address using the keyboard.
Note
When multiple control panel banks are selected,
consecutively numbered IP addresses are set.
8
Press the [Prefix Length] button for [IPv4] and enter
a prefix length in the numeric keypad window.
Note
When multiple control panel banks are selected, the
same prefix length is set for all the control panel
banks.
9
Press [OK].
To identify a control panel bank
Press the [Send Beacon] button in the [Panel] group to
cause the buttons in all control panel banks configured in
the selected control panel to flash for 5 seconds.
Press the [Send Beacon] button in the [Panel Bank] group
to cause the buttons in the selected control panel bank to
flash for 5 seconds.
481
Advertisement
Table of Contents
