Table of Contents
Advertisement
Bus fixed mode
Depending on the transition, the cross-points of the
background A bus and background B bus do not
interchange.
When the fader lever is at the top of its travel, the
background A bus signal is 100% output. When the fader
lever is at the bottom of its travel, background B bus
signal is 100% output.
To execute a manual transition, operate the fader lever in
the direction of the transition as shown below.
Auto transitions are executed regardless of the fader lever
position.
Next transition
Transition
direction
Background
A t B
B t A
Key 1 to key 8
On t Off
(remove)
Off t On (insert)
Notes
• When the background and one or more keys (1 to 8) are
targets of a transition, the transition direction of all
selected background/keys must be the same as the fader
lever operation direction.
• If as a result of an auto transition, the fader lever position
does not match the background/key signal output state, a
non-sync state occurs and LEDs light/flash at both ends
of the transition indicator.
Split fader
Split fader is a function that splits a single fader lever into
left and right, allowing you to control background A bus
and background B bus transitions independently.
The fader lever on the simple-type transition control
block is split into two by pressing the lock button to
unlock the two fader levers for use as split faders.
The split fader levers support the following buses.
• Right fader lever: Background A bus (main)
• Left fader lever: Background B bus
The split fader function can be enabled/disabled for each
switcher bank. You can also change which is the main
fader lever.
For details about setting split fader, see "Enabling/
Disabling Split Faders" (page 398) and "Setting the
main fader lever when using split faders" (page 425).
The following conditions must be satisfied in order to use
the fader lever as split faders.
• Bus fixed mode is set.
• Split faders are enabled.
• Mix or NAM (non-additive mix) is selected for
transition type.
• If the transition type is a clip transition, Mix or NAM
• If the switcher bank operation mode is set to multi
If these conditions are not satisfied, only the main
(background A bus) fader lever can be operated.
When not using split fader lever operation, disable split
faders.
If enabled, a black image or super mix image may be
output when the transition type is changed.
Fader lever
movement
Split fader operation
Top t Bottom
The relationship between the position of the fader lever
Bottom t Top
and the output for a mix transition type is given below.
Top t Bottom
Fader lever position
Bottom t Top
Right lever
(A bus)
Top
Top
Bottom
Bottom
Center
The A bus and B bus output for a NAM transition type is
an image created using non-additive mixing.
The transition indicator displays the progress of the
background A bus.
108
(non-additive mix) is selected for the background
transition type.
program 2 mode, the switcher bank is set to main.
Note
Left lever
(B bus)
Top
Bottom
Top
Bottom
Center
Note
Output
A bus
B bus
100%
0%
100%
100%
0%
0%
0%
100%
50%
50%
Advertisement
Table of Contents
