Initializing Settings (Default Recall) - Sony MKS-X1115 User Manual

Entering parameters by touch operation
You can enter parameters in the parameter adjustment
area.
The entered numeric value is displayed at the top center
of the parameter adjustment area.
There are two types of parameter adjustment area,
depending on the setting value.
Swipe operation type
Touch operation type
This type is displayed when the setting value is an integer
with a narrow range of values.
Press the upper section (+) or lower section (–) to
increment or decrement the numeric value by 1,
respectively.
Swipe operation type
This type is displayed for all setting values other than
touch operation type.
Swipe up/down to increase/decrease the numeric value.
Swipe with two fingers to increase or decrease the
numeric value quickly, and swipe with one finger to
increase or decrease the numeric value slowly.
Using a mouse, press and hold the right button and then
drag to increase a value or press and hold the left button
and then drag to decrease a value.
Entering parameters using the numeric
keypad
Enter a setting value for the parameter using the numeric
keypad and press [Enter].
For details about numeric keypad operations, see
"Numeric keypad window" (page 69).
Note
Pressing [Enter] closes the analog controls window.
Returning parameters to the initial
settings
Press the default recall button.
Touch operation type
The parameters return to the initial status saved data
setting values.
Entering parameters using the utility
control block
Press the [MENU] button in the utility control block to
switch to menu parameter operation mode.
You can set parameters of the currently displayed menu
using the adjustment knobs.
Adjustment knobs 1 to 5 correspond to the parameter 1 to
5 buttons. Adjust parameters by turning the adjustment
knobs clockwise or counterclockwise.
Note
The control panel must be linked with the menu.
For details, see "Linking a Control Panel with the Menu"
(page 80).
Setting parameters using the device
control block
Press the [MENU] button in the device control block to
switch to menu parameter operation mode.
You can set parameters of the currently displayed menu
using the trackball and Z-ring.
• The trackball X-axis direction corresponds to the
parameter 1 button. Adjust the parameter by moving the
trackball left/right.
• The trackball Y-axis direction corresponds to the
parameter 2 button. Adjust the parameter by moving the
trackball up/down.
• The Z-ring corresponds to the parameter 3 button.
Adjust the parameter by turning the Z-ring clockwise or
counterclockwise.
• Press the [FINE] button to switch to fine mode,
enabling fine adjustment of setting values using the
trackball and Z-ring.
Note
The control panel must be linked with the menu.
For details, see "Linking a Control Panel with the Menu"
(page 80).

Initializing Settings (Default Recall)

You can return a menu to the initial status saved data
setting value if a default recall button is displayed.
Notes
• You can initialize a parameter setting values using a
default recall button in the analog controls window.
78