Table of Contents
Advertisement
- PCM-5O1ES
BASIC SYSTEM CONNECTIONS
(with VTR, amplifier and speaker system)
For basic hook up of your PCM-501ES
for digital audio recording,
connect
the unit with a VTR, amplifier and
speaker
system
as
diagrammed
below.
For detailed
instructions
on connecting
the
respective components,
refer to the instruction manual
furnished
with
each
unit.
TAPE
RECORDER
REC
OUT
O000)
o000
,
—
Audio connecting cords
(supplied)
—s
i718) 20)
IN
J OUT
4}
(supplied)
VIDEO IN (PCM IN)
VIDEO OUT ( PCM OUT}
PCM switch ~ to PCM
CAUTION
Your speaker
system could be damaged
if PCM
digital tapes are
copied at high output with VTR if connections are made to the aux-
iliary (AUX) or tuner input jacks. Avoid copying in this manner if at
all possible ; if your set up requires that you make connections in
this manner, be sure to record at a low level.
Proceed in accordance with text as diagrammed :
@ Turn off the amplifier before making connections.
@The supplied connecting cords with the red and white plugs are
for hook
up with audio equipment.
(Connect
these to the LINE
IN/OUT jacks of the PCM unit and the audio component). The cords
with yellow plugs are for hook up with the VTR (Connect these bet-
ween the VIDEO IN/OUT jacks of the PCM and the VTR).
@ Be sure to connect the red plug of the audio connecting cord to
the right-channel (R) jack and the white plug to the left-channel (L)
jack.
e@lnsert connecting
plugs firmly as loose connections
may cause
hum and noise. Also keep connecting cords away from power cords
and speaker cords to avoid hum pick-up, and keep cords away from
antenna leads as this could cause both audio and video reception
interference.
@For quality digital audio recording, we recommend
that you use
Sony Betamax
models.
Amplifier
to a wali outlet
Speaker system
PCM-501ES
Video connecting cords
to a wall outlet
VTR
to a wall outlet
Power cord polarity
A white mark is visible on the lead of the power cord.
This will help to operate the PCM-501ES and the other components
of the system "in phase" by aligning the ac power cord polarities
with the ac outlet polarities. In most cases, the marked plug of the
PCM-501ES
power cord should .be inserted into the grounded side
of the ac outlet.
=
3 —
Advertisement
Table of Contents
