Tcp/Ip Protocol Configuration - Xerox DocuPrint N4025 Information Manual

Quick Step (OS/2 Warp Server V 4.0)
Step-by-Step Setup
for IBM TCP/IP for
7-6 DocuPrint Technical Information Guide

TCP/IP Protocol Configuration

1 Acquire two IP addresses for use on your server and your
OS/2
DocuPrint printer.
2
Install TCP/IP for OS/2. Remember to open LAN Adapter
and Protocol Support (LAPS/MPTS, etc.) and configure the
TCP/IP protocol for your network adapter. (See your OS/2
documentation for configuring network adapters for the
TCP/IP protocol.)
3 Open (double-click) TCP/IP Configuration Object.
• Click the Printing tab and enter the following:
• REMOTE PRINT SERVER = Printer IP Address in 32-bit
dotted decimal notation (e.g. 127.0.0.0).
• REMOTE PRINT SERVER'S PRINTER = ps (Enter ps
without quotes and in lowercase.)
• MAXIMUM NUMBER OF LPD PORTS = Enter a number
between 2 and 64 inclusive.
• FOR OS/2 PRINTING ONLY (NO WIN-OS/2) Click the
Autostart tab. Highlight lprportd, then click Autostart
Service, Foreground Session and Minimized.
• Close the TCP/IP Configuration Windows. Click SAVE,
then reply YES to Update CONFIG.SYS.
• Shutdown your server/workstation and reboot.
Once completed and you have rebooted, use the
"ping" command at an OS/2 Command Prompt to
ping your server/workstation's IP address. Repeat
the ping command using your DocuPrint printer's
IP Address to confirm that your printer is
configured properly for using TCP/IP.