Table of Contents
Advertisement
7.
After all the port settings have been configured and verified, a Completing dialog box appears
summarizing all of the settings. You have the opportunity to change any of the settings by clicking
the Back key. Otherwise, click the Finish key to complete the port setup.
8.
Click OK to exit from Printer Properties. This completes the installation of the Xerox TCP/IP
Port.
Windows NT 4.x troubleshooting (TCP/IP)
This troubleshooting section assumes you have completed the following tasks:
You have loaded a Phaser printer PCL or PostScript print driver.
You have printed and retained a current copy of the Configuration Pages. For information on
printing Configuration Pages, refer to the Front Panel section of the Features Guide on the
Interactive Documentation CD-ROM.
1.
Verify these items in the TCP/IP area of the Configuration Pages:
IP Address Source is set to DHCP, Front Panel, BOOTP, or Auto IP (depending on your
network configuration).
Current IP Address is set correctly. (Note this address if it is assigned by Auto IP, DHCP, or
BOOTP.)
Subnet Mask is set correctly (if used).
Default Gateway is set correctly (if used).
The LPR setting must be enabled. Check the LPR and AppSocket settings and verify they are set
as desired.
2.
Verify the Language in the LPR area of the Configuration Pages:
Interpreters: Auto, PCL or PostScript (depending on your driver).
3.
Verify that the client is logged into the network and printing to the correct print queue. Also verify
that the user has access to the Phaser printer queue.
4.
From the server desktop, use the right-mouse button to click on Network Neighborhood. With
the left-mouse button, select Properties from the cascade menu.
5.
The Network dialog should appear. Select the Protocols tab.
6.
Check the list of installed network protocols for TCP/IP Protocol.
7.
As required, click Add and install any components not listed and restart the system.
8.
Once rebooted, click on Start, select Settings, select Control Panel, and double-click on
Services. Find TCP/IP PrintServer. Verify that the Status column reads "Started" and the Startup
column reads "automatic".
9.
Select the Start button and Settings, then select the Printers folder. The Printers window should
appear.
10.
Right-mouse-click on the printer icon and select Properties.
11.
Verify that you have loaded and selected the correct driver for your printer.
12.
Select the Ports tab.
Phaser® 7300 Color Printer
Windows NT 4.x Network
21
Advertisement
Table of Contents
Troubleshooting
