Table of Contents
Advertisement
Registration of a design into the machine memory
To select a design
(4)
(5)
To read condition file
If the saving format of the selected design is T3 or T2, the following message will appear.
Condition file means Color Change Sequence and Design Start Position.
OK to read
condition data?
(6)
To move frame to the design start position
When performing this operation, do not put your hands etc. on the machine table. Moving
frame could injure you.
OK to move a frame
to the start point of
design data ?
After that, proceed to "To decide color change sequence (Needle Bar Selection)"(→p.53).
46
3
TBF
***
******
****
!
CAUTION
Pressing SET will move the frame, then data set will be
completed.
When the movement of the frame is not desired.
Data set is completed.
Chapter 4
Advertisement
Table of Contents
