To Change Stitching Condition In Every Needle Bar (Setting In Units Of Needle Bar) - TAJIMA TFMX-IIC User Manual

To adjust finishing of embroidering
7-4.

To change stitching condition in every needle bar (Setting in units of Needle bar)

7-4-1. Explanation on the screen
3 Setting in units of Needle bar
Needle No.
SET
Revolution Limit
F1
Thread Detection
Under (Step Ratio)
ATH
Thread trim length
Return stitches
3 Setting in units of Needle bar
SET
Needle No.
F1
Return Stitch Length
Tie Stitch Length
Needle bar No. applied to sewing condition
[a]
Perform the following setting for this needle bar.
Maximum speed
[b]
Number of upper thread breakage detecting times
[c]
Setting how many consecutive detections of upper thread breakage are regarded as thread
breakage
0: Not to stop even if upper thread breaks
When idling the machine, set "Upper" and "Under (Unit)" to "0".
1, 2, 3, 4: To stop if upper thread is broken
When selecting "3", the thread breakage will be detected after upper thread breaks three
times continuously.
The relationship between the number of detecting times and sensitivity is shown as follows.
108
900
rpm
2
Upper thread 0/1/2/3/4
4
Under (Unit) 0/2/4/6/8
80
30 100[%]
+3
-8 +8
2
1/2/T0/T1/T2/NO
To the next page
0.6 [mm]
0.6 2.0
0.6
0.4 [mm]
2.0
1 2 3
High
[Sensitivity]
[a]
[b]
[c]
[d]
[e]
[f]
[g]
[h]
[i]
4
Low
Chapter 5