Table of Contents
Advertisement
To move the frame to the position registered
5.
To move the frame to the position registered
5-1.
To move the frame automatically at the start and the end of embroidery
(Automatic Offset)
This is the setting to move the frame automatically so that replacement of the frame and the fabric to be
stretched can be performed easily. Perform this setting after data set. Setting contents here will be added in
a design. So, when you embroider this design next time, setting again will be unnecessary.
Embroidery starts
[C]
[B]
[A]
(1)
At the start of embroidery, by operating the bar switch or the start switch, the frame will pass from the
offset start position [A] through the offset middle position [B] and move to the design start position [C].
When embroidery is finished, the frame will pass from the design end point [D] to the offset start position
(2)
[A] through the offset middle position [B].
5-1-1.
Explanation on the screen
5 Automatic offset
B
OF1 X
Y
OF2 X
Y
[a]
Offset middle position [B in the figure above]
The position where the frame will pass. This position is arbitrarily set. Set it when embroidered
material hits the machine during the frame travel.
[b]
Offset start position [A in the figure above]
The position where the frame has come to the front. Changing the frame and the fabric to be
stretched will be performed here.
Previous
0
[mm]
0
0
[mm]
0
0
[mm]
0
0
[mm]
0
Completion of embroidery
[B]
[A]
[a]
[b]
Chapter 6
1
2
3
4
5
[D]
6
7
8
9
10
11
165
Advertisement
Table of Contents
