TAJIMA TFMX-IIC User Manual page 234

Countermeasure when the machine stopped
No.
3BD
Refer to 3BD (MC) described above. Driver not
for the main shaft is connected.
S
3BD
Refer to 3BD (MC) described above. Driver not
for X-axis is connected.
X
3BD
Refer to 3BD (MC) described above. Driver not
for Y-axis is connected.
Y
3BF Remaining number of beads cannot be grasped. Check and/or replace the head card.
Contact error of the bar switch or start/stop
3C1 switch, breakage of the switch harness, or bad
connection of the connector
Mis-setting of the number of heads in "Machine
3C3
Type"
There is abnormality in the program or in the
CPU card.
3D6
The software is not installed normally.
3DB Lack of system RAM capacity
3DC Abnormality of memory device
3DD Abnormal system installation
3DE Abnormality of external memory device
6D1 File error of frame drive parameter
6D2 Disconnection of communication line
Disconnection of USB communication line in I/O
6D3
card, communication error
220
Stop Factor How to restore
Check and/or replace the main shaft driver.
Check/replace the X-axis driver.
Check/replace the Y-axis driver.
Check the connector and the connecting
terminal.
Replace the limit switch/switch assembly.
Check the contents of setting.
Check the CPU card.
Install the software.
Turn "OFF/ON" the power.
Replace CPU card.
Turn "OFF/ON" the power. Install the software.
Replace the DOM or CPU card.
Install the software.
Replace DOM or CPU card.
Turn "OFF/ON" the power.
Check/replace the USB memory, or replace the
CPU card.
Install the software.
Turn "OFF/ON" the power.
Check harness connection between CPU card
and USB hub.
Check and/or replace power supply card.
Check and/or replace DC power supply.
Install the software again.
Turn "OFF/ON" the power.
Check connection of USB cable
Check and/or replace power supply card.
Check and/or replace DC power supply.
Install the software again.
Chapter 9