Table of Contents
Advertisement
Countermeasure when the machine stopped
1-2.
Abnormal stop
It is displayed in red on the screen. The trouble will occur when the movement of the machine comes
off from normal position etc.
[2C2]
Wrong setting for optional device
Check the setting for option.
"Reset" >>E
No.
The main shaft has stopped deviating from the fixed
211
position.
221
The embroidery frame moved to the travel limit
position (left) (-X direction).
(*)
222
The embroidery frame moved to the travel limit
position (right) (-X direction).
(*)
223
The embroidery frame moved to the travel limit
position (front) (+Y direction).
(*)
224
The embroidery frame moved to the travel limit
position (rear) (-Y direction).
(*)
The frame move to the limit position during trace.
225
The frame moved to the software limit position
during trace.
Table up/down operation was performed when the
228
frame was positioned at the front.
229 The machine was stopped during Power resume.
251 Oil of lubricating pump is lacking.
258 Upper dead point sensor error (Sequin device III)
259 Lower dead point sensor error (Sequin device III)
25A Sequin color change sensor error (Sequin device III) Check the sensor.
Upper thread breakage is detected.
291
TC sensor card error
293 Under thread breakage is detected.
Absence of sequin material is detected (Sequin
294
device III only).
2B1 Network does not work normally.
Code No.
Stop Factor
Stop Factor
How to restore
Return the main shaft to the fixed position.
Check the main shaft fixed position sensor.
Move the frame manually so that embroidery
can be performed within the set range.
*Only the model that has limit switch at drive
system is applicable.
Press the E key. Check the current frame
position.
Press the E key. Check setting range of
software frame limit.
Move the frame to the rearmost position.
Perform Power resume again.
Lubricate to the lubrication tank.
Check the sensor.
Check the sensor.
Check thread.
Replace TC sensor card.
Check under thread.
Check the material.
Check connecting status of cable, setting
status of device such as personal computer.
Chapter 9
1
2
3
4
5
6
7
8
9
10
11
215
Advertisement
Table of Contents
