Table of Contents
Advertisement
To adjust finishing of embroidering
7-3.
To divide a long stitch (Auto Jump)
This function makes the frame movement to divide by jump automatically when a stitch length exceeds a
setting value. This function reduces the load generated at the frame drive due to heavy weight of the material
to be embroidered. However, dividing by jump will reduce embroidering efficiency.
Explanation on the screen
7-3-1.
2 Auto Jump
F1
Frame Start Timing
R.P.M. Keep
Setting for auto jump
[a]
NO: Not to perform
2.0 to 9.9:
The machine will jump automatically when a stitch exceeding a set value is given. When a
value is 4.0, the machine will jump automatically if stitches of 4.1 mm and more are given.
When the setting of frame type is set to "Auto Clamp Frame", setting range is 2.0 to 5.0 mm.
[b]
Timing to start moving the frame(→p.113)
R.P.M. at auto jump
[c]
YES: To keep (remaining in high speed)
NO: Not to keep (speed reduction according to a stitch length)
How to operate
7-3-2.
The following is an example that stitch length to jump automatically is set to "6.0".
To open screen
(1)
To select stitch length to perform automatic jump
(2)
4.0
[mm]
NO/2.0
9.9
240
240 360 [ ]
NO
Yes/No
2 Auto Jump
6.0
[a]
[b]
[c]
Chapter 5
1
2
3
4
5
6
7
8
9
10
11
107
Advertisement
Table of Contents
