Table Offset Switch - TAJIMA TFMX-IIC User Manual

How to use each part
2-6.

Table offset switch

This operation facilitates threading by moving the frame to the rear (the table offset position) at thread
breakage. Pressing this switch will move the frame to the table offset position. This function is supported by
the machine equipped with the table offset switch.
Table offset switch
2-6-1. How to operate
When performing this operation, do not put your hands etc. on the machine table. Moving
frame could injure you.
The machine stops when thread breaks. Since the movement of the machine differs depending on the switch
operation, perform any one of the following operations. The frame moves in the same way even when the
thread does not break.
Press the switch and release it immediately.
(1)
→ The frame will move to the rear.
Press the switch for two seconds or more.
(2)
→After trimming threads of all heads, the frame will move to the rear.
Since the movement of the machine after passing the thread differs depending on the switch operation,
perform any one of the following operations.
(1) Press the switch and release it immediately.
→ The frame will return to the original position.
(2) Press the start switch, or move the bar switch to the right.
→ The frame will return to the original position and the operation will be started.
(3) Press the stop switch or move the bar switch to the left.
→ The frame will return to the original position and the machine will perform frame back/forward.
(→p.69)
24
Table offset switch
When changing table offset position, refer to the
detail page.(→p.170)
!
CAUTION
Chapter 2
Table Offset Position