Message display
Saving or reading of condition data
2-1-2.
Condition data can be saved or cannot be saved depending on its place to save.
O: Can be saved /
Condition data
1. Color change
sequence
2. Start point of design
3. Data Conversion
4. Repeat of design
5. Automatic Offset
*1: When embroidering the design between models with different embroidery spaces, the start
position of the design may differ depending on the model.
*2: Scaling up/down/rotation/reversion of design
2-2.
Start point of design
OK to move a frame to the
start point of design data ?
[X:+115.7 Y:-153.2]
"YES">>SET
"NO">>E
2-3.
Offset Return
OK to execute Offset
Return?
[X:+65.2 Y:-180.5]
"YES">>SET
"NO">>E
32
: Unable to save
Saving into
machine memory
[*2]
The message shown left will be displayed only when the machine
reads condition data at "2-1.".
This message is displayed when performing data set. Design start
position means the frame position where the embroidery of this
design was started last time.
These figures mean the destination of moving the frame. Frame
coordinates are shown.
The message shown left will be displayed only when the machine
has the setting of "Automatic offset".
This message is displayed when performing data set. Offset
return means the offset start position where this design was
embroidered last time.
These figures mean the destination of moving the
frame. Frame coordinates are shown.
Saving into USB
Saving from DG/ML by
memory
Pulse into the machine
T3, T2
T
[*1]
Chapter 3
memory