To Prevent Displacement Of Design When The Power Is Shut Off During Operation (Power Resume) - TAJIMA TFMX-IIC User Manual

To return the frame to the original position
3-3.
To prevent displacement of design when the power is shut off during operation
(Power resume)
This function works on condition that the frame origin is memorized correctly. If it is wrong, the frame will not
return to the correct position.
Screen
3-3-1.
8 Power Resume
SET
F2
How to operate
3-3-2.
When performing this operation, do not put your hands etc. near the needle or on the
machine table. Moving needle bar or frame could injure you.
The following is an example of executing Power resume.
Set to main screen.
(1)
Press F2 key while pressing SET key.
(2)
Press F2 key.
(3)
158
To return the frame to several stitches before the
position where power was shut off
ATH
!
CAUTION
1 Max. Revolution Limit
8 Power Resume
: Not to execute
: To execute
: To execute after thread trimming
ATH
Chapter 6