To Return The Frame To The Offset Start Position Manually (Return To The Offset Origin) - TAJIMA TFMX-IIC User Manual

To move the frame to the position registered
5-3.

To return the frame to the offset start position manually (Return to the offset origin)

This function makes the frame return to the offset start position in the middle of embroidery when you
stopped the machine. It it possible to operate only when Automatic offset is set. The offset middle position is
not passed.
Screen
5-3-1.
6 Return to the offset origin
How to operate
5-3-2.
When performing this operation, do not put your hands etc. on the machine table. Moving
frame could injure you.
The following is an example of executing offset return.
To open screen
(1)
To execute offset return
(2)
!
CAUTION
6 Return to the offset origin
To return the frame to offset start position
: Not to execute
: To execute
Pressing SET will move the frame. To
return to the original position, perform
"Manual offset".
(→p.156)
Chapter 6
1
2
3
4
5
6
7
8
9
10
11
169