Stop Due To Malfunction - TAJIMA TFMX-IIC User Manual

Countermeasure when the machine stopped
No.
At network connection to host PC, IP address was
BF1
not obtainable from DNS server.
The contents of "IP Setting.ini" file for network set-
BF2
ting was incorrect
It is not possible to input data due to abnormal
5B1
contents of configuration in TCF design.
Data set was performed without frame origin
memory after installation of software.
5C1
The machine was stopped during operation of frame
origin memory.
Machine was started during moving up/down of
5C2
sequin device.
5C3 Setting error of sequin device III
5C6 General external device is operating.
1-3.

Stop due to malfunction

It is displayed in red on the screen. It is caused by card, harness or communication error. If the below
code No. is displayed, consult the distributor.
[3C3]
Information error of head number
The setting conflicts with the actual
"Reset" >>E
No.
Encoder A signal does not change for 5 seconds.
311
Abnormality of motor, motor belt (It is not dis-
played for the single-head machine.)
Fixed position signal (Main shaft Z signal) does
312
not change during operation.
316 Main shaft motor error or main shaft driver error
Abnormality of X-axis driver
322-
Description of mark differs depending on factor.
* *
The same is applied to No.323.
323- Abnormality of Y-axis driver
*
Stop Factor
Code No.
Stop Factor
Stop Factor
How to restore
Check IP address of DNS server. Correct "IP
Setting.ini" file. Check operating condition of
DNS server.
Correct the contents of "IP Setting.ini" file.
Check the design.
Perform frame origin memory.
Start the device after completion of up/down.
Check the setting of panel.
Operate the machine after general external
device is stopped.
How to restore
Check connection of the encoder signal lines.
Check excitation of the main shaft driver.
Check the motor or motor belt.
Press the E key. Check the main shaft motor or
the photo-interrupter card.When recovery is
impossible, replace the main shaft motor or the
photo-interrupter card.
Turn "OFF/ON" the power. Or switch from
sleep mode to normal mode. (Each driver
setting will be reset.) When it is not possible to
recover from the trouble, replace the card.
Chapter 9
1
2
3
4
5
6
7
8
9
10
11
217