Table of Contents
Advertisement
To trim thread
Coming-out amount of hook (thread holder) (2 in the right figure)
[h]
Select B.
A: Short
B: Long
Select "B" for hook. Wrong selection would cause abnormal noise and/or not to hold the
thread normally.
How to operate
2-2-2.
The following is an example that the thread is trimmed automatically, the thread trim length is set to "+2" and
inching after ATH is set to "3".
(1)
To open screen
To trim thread automatically
(2)
To select thread trim length
(3)
When "N" is displayed, changing "N" to a value will set the detecting sensitivity in all needle bars to the
same.
To select number of inching times at start after ATH
(4)
82
!
9 ATH
YES
+2
3
CAUTION
Chapter 5
2
Advertisement
Table of Contents
