Countermeasure When The Machine Stopped; Normal Stop - TAJIMA TFMX-IIC User Manual

Countermeasure when the machine stopped

1.
Countermeasure when the machine stopped
When the machine stops during embroidery, a code No. indicating stop factor will be displayed on the
screen (the illustration below is an example).
Restoring method differs depending on the code Nos. described.
1-1.

Normal stop

It is displayed in green on the screen. It is not a stop by abnormality of the machine.
[1D2]
Preset halt
Stop by Preset halt setting
"Reset" >>E
The list below also includes code Nos. which are not displayed (common to the models).
No.
1B1 Stop by frame stepping code
1B2 Stop by color change code
1B3 Stop by end code
1B4 Stop by thread trimming code
Stop by automatic color change (free setting)
1B6
offset code
1B8 Stop by temporary stop code
Stop by stop switch during frame stepping
Stop by stop switch during trace
1C1
Do not turn OFF the power during display of 1C1. It may not possible to continue embroidery if the
power is turned OFF.
Stop at all-head sewing start point after frame
1D1
back
1D2 Stop by preset halt (except oil, lochrose)
1D5 Stop by Preset halt (run out of beads)
1D8 Stop by Preset halt (ATH cleaning)
OIL Preset halt (Oil)
214
Code No.
Stop Factor
Stop Factor How to restore
Perform "Start operation" or "Frame back/
forward operation", or press any operation key
(excluding manual frame travel key) to continue
operation of the machine.
Start to the machine.
To start the operation again, press SET key. To
reset the setting, press E key.
Start the machine and continue embroidery.
Press the E key.
Lubricate to the necessary spots, and press E
key.
Chapter 9