Table of Contents
Advertisement
Countermeasure when the machine stopped
No.
The machine cannot memorize excitation of X-
32A
axis driver.
The machine cannot memorize excitation of Y-
32B
axis driver.
32C Incompletion of X-axis frame travel
32D Incompletion of Y-axis frame travel
The machine cannot complete X-axis origin
32E
search within the time.
The machine cannot complete Y-axis origin
32F
search within the time.
Abnormal signal of bobbin changer has been
331
detected.
Abnormality occurred in up/down color change
353
driver (Sequin device III only).
Sequin motor, color change motor, ATH motor
overcurrent
354
(Color change motor and ATH motor are
applicable to single-head machine only.)
362 Jump motor overcurrent
The needle position signal status during color
382
change does not change for 1 second and more.
Needle position was abnormal.
383
There was no needle position signal during
rotation of the main shaft.
387 Color change motor sensor error
ATH movable knife retractable position has
3A6
become nonuniform.
3A9 Upper thread holding motor overcurrent
218
Stop Factor
How to restore
Turn "OFF/ON" the power.
Check connection of each frame driver motor
and/or sensor wire.
Replace the corresponding frame driver or
frame motor.
Turn "OFF/ON" the power. Or switch from
sleep mode to normal mode. (Each driver
setting will be reset.) When it is not possible to
recover from the trouble, replace the card.
Check setting for embroidery space at software
installation. Check the sensor card.
Operate the bobbin changer manually after
resetting the error, and check/adjust the place
where motion error occurred.
Check the card.
Turn OFF/ON the power. Check and/or replace
the head card. Decrease rpm.
Check the color change motor and power
supply circuit.
Check the potentiometer (needle position
sensor).
Check setting for the number of needles at
installation of software.
Check the potentiometer (needle position
sensor).
Check encoder signal wire of color change
motor.
Check the position of ATH movable knife.
Turn OFF/ON the power. Check and/or replace
head card.
Chapter 9
Advertisement
Table of Contents
