To Return The Frame To The Design Start Position; To Return The Frame To The Design Start Position Manually (Return To The Design Start Position) - TAJIMA TFMX-IIC User Manual

To return the frame to the design start position

4.

To return the frame to the design start position

4-1.

To return the frame to the design start position manually (Return to the design start position)

This function makes the frame return to the design start position in the middle of embroidery when you
stopped the machine.
4-1-1. Screen
4 Return to the design start position
How to operate
4-1-2.
When performing this operation, do not put your hands etc. on the machine table. Moving
frame could injure you.
The following is an example of executing design start position return.
To open screen
(1)
To execute design start position return
(2)
!
CAUTION
4 Return to the design start position
To return the frame to the design start
position
: Not to execute
: To execute
Pressing SET will move the frame. To
return to the original position, perform
"Manual offset".
(→p.156)
Chapter 6
1
2
3
4
5
6
7
8
9
10
11
163