TAJIMA TFMX-IIC User Manual page 8

Contents
Chapter 6 Functions concerning frame movement
1.
To return the frame (Frame Back) / to advance the frame (Frame Forward) ..................... 146
To switch Frame Back / Frame Forward ................................................................... 146
1-1.
To execute by Stop code, to specify number of stitches to execute.......................... 147
1-2.
To change a frame feed amount of frame back / frame forward ............................... 149
1-3.
1-4. To set All Head Sewing Start Point (Frame Back All Head Sew) .............................. 150
2.
Necessary works after replacing the frame ........................................................................ 152
To change frame type................................................................................................ 152
2-1.
To rotate the design by 180 degrees when a cap frame is equipped
2-2.
(Design rotation by 180 degrees on Cap Frame) ...................................................... 155
3.
To return the frame to the original position......................................................................... 156
3-1. To return the moved frame to the previous position (Manual Offset) ....................... 156
3-2. To return moved frame to original position and start operation
(Return the frame after manual frame travel) ............................................................ 157
To prevent displacement of design when the power is shut off during operation
3-3.
(Power resume) ......................................................................................................... 158
3-4. To memorize frame origin (Frame origin memory) .................................................... 159
To perform Frame origin memory when the power is turned ON
3-5.
(Frame origin memory with the power-ON) ............................................................... 160
To perform power resume when the power is turned ON
3-6.
(Power Resume with the power-ON) ......................................................................... 162
4.
To return the frame to the design start position.................................................................. 163
4-1. To return the frame to the design start position manually
(Return to the design start position).......................................................................... 163
To return the frame to the design start position automatically (Auto Origin Return).. 164
4-2.
5.
To move the frame to the position registered ..................................................................... 165
To move the frame automatically at the start and the end of embroidery
5-1.
(Automatic Offset)...................................................................................................... 165
5-2. To move the frame automatically at the start,
in the middle and the end of embroidery ................................................................... 167
To return the frame to the offset start position manually (Return to the offset origin) 169
5-3.
6.
To register frame position................................................................................................... 170
To register the frame position to make threading easily (table offset position) ......... 170
6-1.