Embroidery Head - TAJIMA TFMX-IIC User Manual

Check items before embroidering
6-2.

Embroidery head

Check the position of the following tension base switch, needle bar suspension lever, middle thread guide
adjusting lever before embroidery.
Regarding the tension base switch and the needle bar suspension lever, embroidering is possible only when
both of them are set to "ON".
Tension base switch
(1)
This switch will suspend the head electrically.
The switch operation during working of the machine is invalid. Even if the switch operation is performed,
it will become effective after the machine stops.
Thread breakage indicator lamp
Lit in green
Unlit
Blinking in
green
Lit in red
Blinking in red
66
Tension base switch
Ready to embroider
Embroidery is suspended. (Needle bar will not move down.)
Frame back section at the head without thread breakage. The lamp at the
head without thread breakage blinks in green during Frame Back
Regarding Frame Back, refer to the detail page.(→p.69)
Upper thread breakage
Under thread breakage
Green Red
Unlit Lit
OFF
Chapter 4