Table of Contents
Advertisement
Countermeasure when the machine stopped
No.
2B3 Data exists in an end code.
2B4 Function code error
2B5 Sequin data error
2B7 Data set is not completed.
2BA Memory capacity exceeded
Available range to perform frame back was
2BB
exceeded.
No design is registered in the memory at all.
The delete of design in process of embroidery was
2BC
attempted.
Data edit was attempted during embroidery.
Start and End codes are not set as a one pair in
2BE
satin conversion, sequin, boring and low speed
code.
Machine was started during setting of data edit or
2C1
needle bar selection.
2C2 Setting for option is incorrect.
The machine was operated during working of
2C6
bobbin changer.
2C7 Wrong password is input.
2C8 Sleep mode key was pressed during trace.
Time was changed during setting of Password
2C9
(Time-based Limit).
2CA The power is not turned "OFF/ON".
2CE Stop by safety device
Air pressure of the regulator has become lower than
2E2
the rated value.
2E3 Power supply failed during operation.
B01 Abnormality occurred in reading/writing.
B04 USB memory is not inserted.
BC1 Design tried to input is not in design spooler.
BC2 The same file name exists in USB memory.
BC5 Insufficient remaining capacity of USB memory
216
Stop Factor
How to restore
Correct design data.
Set data.
Delete unnecessary design(s) registered in
the memory.
Do not perform frame back any more.
Register designs in the memory.
To perform memory delete of design in
process of embroidery, perform data input of
other data or perform data input of the same
design again.
Do not perform data edit during embroidery.
Set again so that start and end codes
become as a pair.
Start the machine after ending the setting.
Set correctly.
Do not operate the machine during working
of bobbin changer.
After pressing E key, input the correct
password.
Press the E key.
Press the E key.
Turn "OFF/ON" the power.
After removing the obstacle, press E key,
then press the start switch.
Check the air compressor. Check the origin
of air supply.
Perform power resume operation after
turning ON the power.
Copy design to a new USB memory and use
it.
Insert.
Check the condition of design spooler.
Change the file name.
Replace with a USB memory with enough
remaining capacity.
Chapter 9
Advertisement
Table of Contents
