To Return The Frame To The Design Start Position Automatically (Auto Origin Return) - TAJIMA TFMX-IIC User Manual

To return the frame to the design start position
4-2.

To return the frame to the design start position automatically (Auto Origin Return)

This is the setting to return the frame to the design start position automatically after embroidery is finished.
When Automatic offset is set, the frame will return to an offset start position.(→p.165)
Screen
4-2-1.
4 Automatic Origin Return
How to operate
4-2-2.
After embroidery is finished, do not put your hands etc. on the table. Moving frame could
injure you.
The following is an example of setting Automatic origin return.
To open screen
(1)
(2) To make auto origin return effective
164
!
CAUTION
4 Automatic Origin Return
YES
NO
Auto Origin Return
YES: To set
NO: Not to set (usual setting)
NO
Chapter 6