Table of Contents
Advertisement
Message display
2.
Message display
2-1.
Condition data
When registering the design (saving format is T3, or T2 design) saved in the USB memory into the machine
memory, the following message will appear.
OK to read condition
data?
"YES">>SET
"NO">>E
There are following three items of condition data except the one described above. By setting them after data
set, each setting contents will be added in a design. Therefore, it is unnecessary to perform setting again
when you embroider this design next time.
(1)
Scaling up/down/reversion of design
Design repetition
(2)
(3)
Automatic Offset
2-1-1.
When reading the design (Example: TAJIMA_W) saved in the USB memory by a personal computer
Indications in a personal computer are different as shown in the chart below depending on the saving format
(T3, T2, T) of the design.
Saving format
T3
T2
T
[About T2]
One design consists of three types of file (TAJIMA_W.CT0, TAJIMA_W.DGF, TAJIMA_W.TBF).
Condition data means the following two items in this case.
(1)
(2)
Indication in personal
computer
TAJIMA_W.TCF
Data integrating CT0, DGF and TBF of T2
TAJIMA_W.CT0
Color change sequence, design start point
TAJIMA_W.DGF
Redeced-size design data (Thumbnail)
TAJIMA_W.TBF
Stitch data of TAJIMA binary format
TAJIMA_W.DST
Stitch data of TAJIMA ternary format
Color change sequence
The whole color change sequence included in the design
can be registered into the machine memory. Therefore, it
is unnecessary to set it again.
Start point of design
The frame position where the machine started
embroidering last time can be registered in the machine
memory. Therefore, it is unnecessary to adjust the
position of the frame.
Use
Chapter 3
1
2
3
4
5
6
7
8
9
10
11
31
Advertisement
Table of Contents
