Hydraulic Pump P.t.o. Group 1; Hydraulic Pump 3Rd P.t.o., Group 2; Hydraulic Pump 4Th P.t.o., Group 1; Use Of 3Rd And 4Th P.t.o - Kohler KD 625/3 Workshop Manual

4
Disassembly / Reassembly
102
103
104
105
- 46 -

Hydraulic pump p.t.o. group 1

A hydraulic pump of group 1 or 2 can be installed on the gear side A,
3rd p.t.o.
A group 1 hydraulic pump can be installed at the 4th p.t.o. B.

Hydraulic pump 3rd p.t.o., group 2

Components:
1 Gear
2 Gear support
3 Bearing
4 Drive
5 Flange
6 Washer
7 Seal ring
8 Circlip
A max torque of 39,6 Nm can be obtained from this p.t.o.

Hydraulic pump 4th p.t.o., group 1

Components:
1 Drive
2 Control shaft
3 Pin
4 Gear
5 Washer
6 Nut
A max. torque of 243 Nm can be obtained from this p.t.o.

Use of 3rd and 4th p.t.o.

1 Hydraulic pump, group 2, mounted at 3rd p.t.o.
2 Hydraulic pump, group 1, mounted at 4th p.t.o.
Total power obtainable from 3rd and 4th plo. is 13 kW ( 17.7 HP).
Ratio for both p.t.o. compared to the engine r.p.m. is 1:1 for 4
1 : 1,067 for 3 PTO.
th
KD Workshop Manual_cod. ED0053029350_1° ed_ rev. 00
7 Seal ring
8 Seal ring
9 Centering ring
10 Bracket
11 Gasket
12 Cover
PTO is
th